Commands used to control a zc-smart-blind
Creation date: 2/6/2024 8:49 AM
Updated: 2/6/2024 8:50 AM
This article outlines the commands to be sent to a zc-smart-blind for control of the attached blind
| DALI command | Blind Behaviour |
|---|---|
| RECALL MAX | Blind all the way up |
| MASK | Blind stop |
| OFF | Blind all the way down |
| UP | Nudge the blind up (used for long press repeat messages) |
| DOWN | Nudge the blind up (used for long press repeat messages) |
| RESET | Reset the calibration of the blind motor |
Additional information about the smart blind controller can be found at https://zencontrol.com/smart-blind/