Error "Sequence command does not support gateway or zone link IP"
Question:
A problem whilst testing some sequences today that required a call to zencontrol to resolve...
A problem whilst testing some sequences today that required a call to zencontrol to resolve...
After making some changes and saving a fairly basic sequence I received the following error
"Sequence command does not support gateway or zone link IP"
you're issue is caused by
having a remote target set when you switched to the "Jump to action"
General function.
To resolve it - either delete the line and add a new one, or switch back to DALI command, wait for it to save then toggle the target back to Local controller (switch to something else then back) before making the change.
To resolve it - either delete the line and add a new one, or switch back to DALI command, wait for it to save then toggle the target back to Local controller (switch to something else then back) before making the change.
It turns out that I had an action set in my sequence (Set lighting to a warn level on another controller) but later changed it to a Jump action before saving.
There was an issue with my original command saving to the sequence (this was the error) and it wouldn't accept that I had just changed it to A "Jump to action 3" command. Essentially the action had locked up and would not write my new command to the space until it was reset (Even though the cloud had accepted the command when I had the sequence open).
Advice from zencontrl if this pop's up again in the future is to remove the Action line that is causing issues and start again (Which is hard to know which is the problem when the errors don't reflect in the cloud) OR Reset the action to something basic (Recall Max on target) save to the sequence, then go back in and adjust the sequence again
DataImage55.png
| Files | ||
|---|---|---|
|
|
DataImage55.png
604 KB
|